Replacing the main accumulator sphere
|
|
- Put the car at it's lowest position.
- Loosen the bleed screw.
- Unscrew the sphere on the main accumulator (on models with manual gearbox you must under the car).
- Put a little LHM on the new gasket and fasten it on the accumulator, not the sphere.
- Put a little mineral grease on the contact surfaces, and screw on the new sphere. Tighten only with your hands.
- Start the engine and allow 5-10 minutes at idle to get out air bubbles.
- Tighten the bleed screw and lift the car up and down a few times.
- Check the LHM level.
|
|
|
